The Cash register packing flow uses a pick list as an input. In this flow users can perform picking and packing in one step, therefore the input pick list does not have to be picked.
Select a packing line from the list. Every active packing line from the warehouses assigned to the thin client are listed.
If there are already started logistic units on the packing line, the ‘Select a logistic unit to pack on’ screen is displayed. On this screen every packed logistic unit, which is not yet shipped, is listed. The customer name and address is displayed for each logistic unit. To continue packing onto a logistic unit, select the logistic unit and press the right key button. To start a new logistic unit, press the ‘Start new logistic unit’ button.
On the next screen select a pick list. Every pick list that meets the following conditions is displayed:
On the next screen the items to pack are listed.
The following barcodes can be scanned on this screen:
Each scanned barcode increases the quantity by one if valid stock can be found. Over picking is not allowed.
If there is at least one item where the ‘Quantity to pack’ is not zero, the ‘Add items’ button becomes active. Press this button to pack the ‘Quantity to pack’ amount of the selected items.
If there is a stated logistic unit for the pick list, the system adds the packed items to that logistic unit.
If there is no stated logistic unit for the pick list, then the system checks whether there are started logistic units for the customer. If there are, then the user can continue the packing onto one of those logistic units or create a new one. If there are no started logistic units for the customer, the system automatically creates a new one.
The started logistic unit is displayed on the top right corner of the screen.
If the item to add is managed by serial numbers and not all serial number were scanned, then the serial numbers has to be scanned before packing the item. On the next screen indicate whether you would like to scan the serial numbers one by one or you would like to scan the starting and ending serial number only. For more information about adding the quantity by scanning the serial numbers please see: Screens for entering additional information
If there is at least one product packed onto the logistic unit, the ‘Finish logistic unit’ button becomes active. Press this button to finish the logistic unit.
If configured, the Packing: finished logistic unit event (500) print event is triggered and the SSCC label is printed. After finishing a logistic unit, the system displays the shipping dock where the logistic unit has to be moved.
If the ‘Ask weight?’ or ‘Ask weight Sub SSCC?’ option is set to true on the Produmex pick list types user table for the pick list, and there is a scale defined under the shipping dock/packing line, the weight of the logistic unit can be measured on the connected scale after the logistic unit is finished.
Make sure that conversions between the units of measurements are set up correctly on the Units of Measure - Setup (OUOM) and Weight - Setup (OWGT) SBO standard tables.
Switch scalebutton is displayed on the screen. Tap this button to change the scale.
It is possible that there are goods that cannot be packed. Continue the packing until only products that cannot be packed are listed on the screen.
Skip all items button to skip every remaining item.
On the next screen confirm that you would like to skip the remaining items.
The system proceeds to the Select a reason screen.
Select a reason from the list. Every reason that can be used for picking is listed.
On the next screen define where the skipped items should be moved.
New SSCC buttonthen identify the destination location as described below. If configured, the 700 - WHS: created LU print event is triggered and the logistic label is printed.
Select locationbutton to list every active location from the warehouse.
Select empty locationbutton to list every empty active location from the warehouse.
Please note: If no SSCC is created or selected, the items will be moved without a linked logistic unit.
After the destination location is defined, the system removes the locking from the skipped products and updates the pick list.
After the lockings are removed, the skipped products are moved onto the selected logistic unit or destination location. Then the system returns to the Select moveable location screen where the user can continue the packing.