==== 3.3.3. Configure the Produmex SB1 Notification Listener ====

Note: Make sure you do not perform the configuration on an environment with active users.

In order to activate the SB1 Notification listener, you need to enable the Service Broker as follows.

1. On the Produmex Suite Installer screen click the ''Config'' button of the Produmex SB1 Notification Listener. 

2. Click the ''Run in console mode'' button of the Configuration Database option.

{{ :implementation:wms:installation:configure_database.png |Configuring Produmex SB1 Notification Listener}}

It shows the following console.

{{:implementation:Installer_SB1Notif_2.png?nolink|Produmex SB1 Notification Listener}}

3. Press ''ENTER'' to finish the database configuration.

Now list the actions that the Produmex SB1 Notification Listener needs to listen to by proceeding as follows.\\

4. Click the ''Run in console mode'' of the List Actions option.

{{ :implementation:wms:installation:list_actions.png |Configuring Produmex SB1 Notification Listener}}

The tool adds the actions to the config-file located in the installation folder of the Produmex SB1 Notification Listener.

{{:implementation:Installer_SB1Notif_4.png?nolink|Produmex SB1 Notification Listener}}

5. Press ''ENTER'' to exit and close the screen of the options.

6. Click ''Save'' on the Produmex Suite Installer screen and close it. 

Continue with section [[implementation:wms:install_storedprocedures|3.4. Adaptation of stored procedures.]]