Add (define) quantity by scanning the serial numbers
The quantity of serial managed items can or must be added by serial number scanning, depending on their management method. WMS supports multiple ways for adding quantity by serial number scanning.
It is possible to remove an already scanned serial number. Go to the list of already scanned serial numbers. When the list is too long to be displayed on one screen, use the green arrows to scroll through the list. Select the serial number and press the ‘Delete’ button on the toolbar.
| |
Serial numbers
Scan the serial numbers one by one. The serial number is immediately validated after scanning.
The successfully scanned serial numbers are listed on the screen. On the top of the scanner field, the screen displays the number of the products that have been already scanned and the maximum number of products.
After having all the serial numbers scanned, proceed by pressing the right arrow button.
| |
Serial numbers - Range
Scan the start range (first serial number) and the end range (last serial number). After scanning the two serial numbers, proceed by pressing the right arrow button. Serial number validations run after proceeding from the Scan a serial number screen.
The system calculates the entered quantity based on the number of serial numbers in the range. Confirm the quantity by pressing 'OK'.
After confirming the quantity, the list of scanned serial numbers is displayed. Press the right arrow button or 'Enter' to proceed.
| |
Serial numbers - Bulk
Scan the serial numbers one by one. Serial numbers are only validated after the forward button is pressed.
If there is an issue with the scanned serial numbers, only the first error is displayed. Acknowledge the error by pressing 'OK'. The system goes back to the list of scanned serial numbers.
This input method is implemented in the following flows:
| |
